I
4Touch a programmable button.
5Dial ✱ 09 plus the slot number of the module to be removed (01 through 11) to select that slot
The green light next to Intercom Ring will flash. The red light next to Intercom Voice indicates activity on the module.
Flashing red light =activity
Steady red light =no activity
NOTE: Digital station modules with only data calls active do not show the flashing red light for activity. Extra care is needed to avoid dropping active data calls.
If the red light is flashing, or if the module has MPDMs or MTDMs connected to it that have the “Call In Progress” light on, skip this module by dialing ✱ 09 plus a new slot number. If you reset the module when it is active, any active voice or data calls will be dropped.
If you decide to change a digital module despite the presence of active calls, remove the station cords before resetting the module.
6To idle a module, touch Intercom Voice. The
appropriate module will be idled.
The red light will be on steady next to Intercom Voice.
The green light next to Intercom Ring will go on steady.
7Remove all line and/or station cords connected to the module that is to be removed.
8Replace the designated module with a module of the same type.
9Reconnect all line and/or station cords that were connected to the module.
10Touch Intercom Ring to restore the module.
The red light on the Processor Module will go on for a short time.
11Repeat steps 4 through 10 for any other module to be replaced.
