UPGRADE lNSTRUCTIONS FM1 OR FM2 TO R3

3 Press [More], [More], [Print], [All]

Wait until printing is complete before leaving administration mode. Don’t remove the printout until after you’ve left administration mode or printing page alignments will be affected.

4 Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

With a BIS-34D Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

Lights flash next to Adm Tel, Adm Pool, Message and Speaker.

3Press Message.

4Dial #999 and wait for the beep.

5Press Message.

Wait until printing is complete before leaving administration mode. Don’t remove the printout until after you’ve left administration mode or printing page alignments will be affected.

6Leave administration mode by sliding the T/P switch to the center position.

Follow these steps to upgrade the system from either Feature Module 1 or Feature Module 2 to Release 3.

1 Shutdown the system, Basic Carrier first, any Auxiliary Power Units next and the Expansion Carrier last if there is one.

Upgrading an Existing System 2-133

Page 201
Image 201
AT&T 518-600-016 manual With a BIS-34D Console