AT&T 518-600-016 manual Press Adm Pool, Press the line buttons until your selection is shown

3 Press Adm Pool.

Green light comes on steady and two beeps sound.

4 Dial the pool code.

5 Press line buttons until your selection is shown:

Red light on = line in pool

Red light off = line not in pool

SPECIFYING TOUCH- TONE OR ROTARY SIGNALING

6 Press Adm Pool.

7 Press Conference to continue administration or leave administration mode by sliding the T/P switch to the center position.

Refer to Form la, System Form-Incoming Lines for Release 3, or the System Configuration Form for Feature Module 2 to determine if the system contains any rotary lines. If it does, follow the appropriate procedure below:

With a Display Console

1Enter administration mode by sliding the T/P switch to P.

2Press Conference twice.

The administration menu appears.

3Press [Lines], [More], [TchTone].

4Press the line buttons until your selection is shown:

Green light on = Touch-Tone signaling

Green light off= rotary signaling

NOTE: Lights next to tie line buttons do not light when you perform this procedure.

5Press Conference to return to the administration menu or leave administration mode by sliding the T/P switch to the center position.

Administering a New System 3-35