Testing the System
TESTING THE VOICE TERMINAL JACKS FOR A DIAL TONE
Testing for an lntercom Dial Tone
Perform the following tests to determine that the system is working properly. If these tests reveal any problems, refer to Section 4, ‘Troubleshooting,” and take corrective action
To test each voice terminal jack for intercom and outside line dial tones at the control unit location, follow the steps below. Refer to “Default Settings” on page
Before you begin testing, follow these steps:
1Make sure the outside lines are connected to the system.
2Take your administrator/attendant console to the control unit.
3Unplug the jumper cord from the jack on the control unit for Intercom 10 (jack location 01), and plug in the modular voice terminal cord for the console you are
using for the test.
The red light goes on next to the third button down in the leftmost column of buttons.
1 Touch the fifth button down in the leftmost column of buttons
The red light goes on next to this button.
2 Pick up the handset.
The green light next to the red light goes on and you hear an intercom dial tone.
3 Replace the handset and touch the fourth button down in the leftmost column of buttons
The red light goes on next to this button.
