Cisco Systems OL-7029-01 manual Agent DFP submode, Dfp, Manager DFP submode Show module csm dfp

Chapter 2 Content Switching Module with SSL Commands

agent (DFP submode)

agent (DFP submode)

To configure the DFP agent to which the CSM is going to communicate, use the agent command in the SLB DFP submode. To remove the agent configuration, use the no form of this command.

agent ip-address port [keepalive-timeout [retry-count [retry-interval]]]

	no agent ip-address port
Syntax Description	ip-address	IP address of the DFP agent.
	port	Port number of the DFP agent.
	keepalive-timeout	(Optional) Time period in seconds between keepalive messages; the
		range is from 1 to 65535.
	retry-count	(Optional) Number of consecutive connection attempts or invalid
		DFP reports received before tearing down the connections and
		marking the agent as failed; the range is from 0 to 65535.
	retry-interval	(Optional) Interval between retries; the range is from 1 to 65535.
Defaults	Keepalive timeout is 0 (no keepalive message).
	Retry count is 0 seconds (0 seconds allows infinite retries).
	Retry interval is 180 seconds.
Command Modes	SLB DFP configuration submode
Command History	Release	Modification
	CSM release 1.1(1)	This command was introduced.
	CSM-S release 1.1(1)	This command was introduced.
Examples	This example shows how to initiate the DFP agent, configure a 350-second timeout, and configure the
	number of retries to 270:
	Cat6k-2(config-slb-dfp)#agent 111.101.90.10 2 350 270
	dfp
Related Commands
	manager (DFP submode)
	show module csm dfp

Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference

OL-7029-01 2-11