Cisco Systems OL-7029-01 manual Snmp enable traps slb ft, 153

Chapter 2 Content Switching Module with SSL Commands

snmp enable traps slb ft

snmp enable traps slb ft

To enable or disable fault-tolerant traps, use the snmp enable traps slb ft command. To disable fault-tolerant traps, use the no form of this command.

snmp enable traps slb ft no snmp enable traps slb ft

Defaults	This command has no default settings.
Command Modes	Module CSM configuration submode
Command History	Release	Modification
	CSM release 3.1(1)	This command was introduced.
	CSM-S release 1.1(1)	This command was introduced.
Usage Guidelines	A fault-tolerant trap allows the CSM to send an SNMP trap when the CSM transitions from standby to
	active after detecting a failure in its fault tolerant peer.
Examples	This example shows how to enable fault tolerant traps:
	Cat6k-2(config-module-csm)# snmp enable traps slb ft

	Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01		2-153