Cisco Systems OL-7029-01 manual Ip slb mode csm rp no ip slb mode Csm

Chapter 2 Content Switching Module with SSL Commands

ip slb mode

ip slb mode

Syntax Description

Defaults

Command Modes

Command History

To operate as a CSM load-balancing device instead of a Cisco IOS server load balancing (SLB) device, use the ip slb mode command to configure the switch. To remove the mode configuration, use the no form of this command.

ip slb mode {csm rp} no ip slb mode

csm	Keyword to select the CSM load-balancing mode that allows you to
	configure a single CSM only and prohibits the use of Cisco IOS SLB
	on the Catalyst 6500 series switch.
rp	Keyword to select the route processor Cisco IOS SLB mode and
	enable module CSM commands for configuring multiple CSMs.
Route processor mode
Global configuration
Release	Modification
CSM release 1.1(1)	This command was introduced.
CSM release 2.1(1)	This command now enables module csm commands for the rp mode.
CSM-S release 1.1(1)	This command was introduced.

Usage Guidelines We recommend that you use the rp mode for all configurations. The rp mode allows you to configure both the switch and the CSM or other modules without changing modes.

Note You need to reboot the switch to change the mode.

This command allows you to change from the Cisco IOS SLB mode to the CSM load-balancing mode.

Note Specifying the no ip slb mode command is the same as specifying the rp mode.

Note In csm mode, all ip slb commands apply to a CSM module; Cisco IOS SLB is not available. In rp mode (the default), ip slb commands apply to Cisco IOS SLB. The module csm commands are available to configure multiple CSMs.

Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference

2-22 OL-7029-01