Cisco Systems OL-7029-01 manual Track fault tolerant submode, Preempt fault tolerant submode

Chapter 2 Content Switching Module with SSL Commands

track (fault tolerant submode)

track (fault tolerant submode)

To set the fault-tolerant tracking for the gateway, HSRP group, or interface of the CSM, use the track command in the SLB fault-tolerant configuration submode.

track {gateway ip_addr group group_number interface {async ctunnel dialer fastethernet gigabitethernet} mode {all any}}

Syntax Description	gateway ip_addr	Configures a gateway or host for tracking.
	group group_number	Configures an HSRP group for tracking.
	interface async ctunnel	Configures an interface for tracking. The interfaces can be
	dialer fastethernet	asynchronous, tunnel, dialer, fast Ethernet, or Gigabit Ethernet.
	gigabitethernet
	mode all any	Configures tracking mode for all devices or any device.
	The default setting for mode is any.
Defaults
Command Modes	SLB fault-tolerant configuration submode
Command History	Release	Modification
	CSM release 4.2(1)	This command was introduced.
Usage Guidelines	The CSM with the largest priority value is the primary CSM in the fault-tolerant pair when the modules
	are both operating.
Examples	This example shows how to set tracking mode for all devices:
	Cat6k-2(config-slb-ft)# track mode all
	ft group
Related Commands
	preempt (fault tolerant submode)
	show module csm ft

Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference

2-20 OL-7029-01