Cisco Systems OL-7029-01 manual Clear module csm

Chapter 2 Content Switching Module with SSL Commands

clear module csm

clear module csm

To force the active CSM to become the standby module, use the clear module csm command.

clear module csm [slot all] arp-cache ip-addressconnections [real vserver] counters ft active linecard-configuration sticky [1-255 all]

Syntax Description	slot	(Optional) Specifies the CSM location in the switch. Range is from 1
		to 9.
	all	(Optional) Applies to all online CSM modules.
	arp-cache ip-address	Clears the SLB ARP cache.
	connections	Specifies connections.
	real	(Optional) Clears SLB connections for the real servers.
	vserver	(Optional) Clears SLB connections for a virtual server.
	counters	Clears SLB statistics.
	ft active	Clears the CSM fault tolerance state to force a failover.
	linecard-configuration	Clears the configuration database stored in the SLB linecard
	sticky	Specifies sticky.
	1-255	(Optional) Clears the designated sticky group; range is from 1 to 255.
	all	(Optional) Clears all sticky entries from the sticky database.
Defaults	This command has no default settings.

Command Modes

Command History

Privileged

Release	Modification
CSM release 3.2(1)	This command was introduced.
CSM-S release 1.1(1)	This command was introduced.

Usage Guidelines When a connection is closed, a reset (RST) is sent to both the client and the server. Counters reset all the CSM statistics information, except for the show mod csm X tech-supportcounters, which are reset any time that you run the show command. The linecard-configurationcommand forces a soft-reset of the CSM, which erases all existing connections and run-time information. The CSM then reloads its configuration from Cisco IOS. This process takes about 3 seconds.

The ft active command is used to force the active CSM to the failover state. Fault tolerance preempt must not be enabled.

Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference

2-8 OL-7029-01