Cisco Systems OL-7029-01 manual Interval probe submode, Interval seconds no interval

Chapter 2 Content Switching Module with SSL Commands

interval (probe submode)

interval (probe submode)

To set the time interval between probes, use the interval command in the SLB probe configuration submode. To reset the time interval between probes to default, use the no form of this command.

interval seconds no interval

Syntax Description	seconds	Number of seconds to wait between probes from the end of the
		previous probe to the beginning of the next probe; the range is from
		2 to 65535.
Defaults	The default value for the interval between probes is 120 seconds.
Command Modes	SLB probe configuration submode
Command History	Release	Modification
	CSM release 1.1(1)	This command was introduced.
	CSM-S release 1.1(1)	This command was introduced.
Usage Guidelines	This command is used for all probe types.
Examples	This example shows how to configure a probe interval of 150 seconds:
	Cat6k-2(config-slb-probe-http)# interval 150
	probe
Related Commands
	show module csm probe

Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference

OL-7029-01 2-63