Cisco Systems OL-7029-01 manual Pending virtual server submode, Pending timeout no pending, 171

Chapter 2 Content Switching Module with SSL Commands

pending (virtual server submode)

pending (virtual server submode)

To set the pending connection timeout, use the pending command in the SLB virtual server configuration submode. To restore the default, use the no form of this command.

pending timeout no pending

Syntax Description	timeout	Seconds to wait before a connection is considered unreachable.
		Range is from 1 to 65535.
Defaults	The default pending timeout is 30 seconds.
Command Modes	SLB virtual server configuration submode
Command History	Release	Modification
	CSM release 2.2(1)	This command was introduced.
	CSM-S release 1.1(1)	This command was introduced.

Usage Guidelines

Examples

Related Commands

This command is used to prevent denial-of-service (DOS) attacks. The pending connection timeout sets the response time for terminating connections if a switch becomes flooded with traffic. The pending connections are configurable on a per-virtual-server basis.

This example shows how to set the number to wait for a connection to be made to the server:

Cat6k-2(config-slb-vserver)# pending 300

advertise (virtual server submode) show module csm vserver redirect

	Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01		2-171