Schneider Electric 58 TRX manual Communication Options

Altivar® 58 TRX AC Drives

Communication Options

COMMUNICATION OPTIONS

All ATV58 TRX functions are available with the communication options:

•Configuration (accessible in read and write modes): motor frequency, motor voltage, ramp profiles, I/ O assignment, etc.

•Adjustments (accessible in read and write modes): DC injection time and amplitude, thermal protection, speed range, ramp time, current limitation, etc.

ComCards.tif

Communication Options

•Control (accessible in read and write modes): start/stop, braking, frequency reference, fault reset, etc.

•Display (accessible in read only mode): speed controller status register, motor speed, motor current, logic I/O status register, fault register, etc.

•Authorization of local control (via terminal block).

Twelve communication options are available:

•FIPIO (VW3A58301U or VW3A58311 for ATV58 TRX 125–500 hp and Type FVC)

This card is equipped with a male 9-pin SUB-D connector, which will accept a TSX FP ACC2 mobile connector for ATV58 TRX Type E and Type F models or a TSX FP ACC12 mobile connector for ATV58 TRX Type H and Type FVC models.

•Modbus Plus (VW3A58302U)

This card is equipped with a female 9-pin SUB-D connector, which will accept a Modbus Plus drop cable equipped with connectors (reference 990NAD21910 or 990NAD21930) to be connected on a T-junction box (990NAD23000) for connection to the Modbus Plus main cable (490NAA271••).

•Modbus RTU/Jbus, Modbus ASCII, Uni-Telway (VW3A58303U)

This card is equipped with a female 9-pin SUB-D connector and includes a 3-meter (9.8 foot) cable equipped with a male 9-pin connector and a male 15-pin connector.

•Interbus-S (VW3A58304EU)

This card is equipped with two male and female 9-pin SUB-D connectors for connection to cables equipped with connectors. It is also equipped with two screw terminals for a separate 24 Vdc power supply (200 mA minimum, which must be ordered separately).

•AS-i Bus (VW3A58305)

This card is equipped with a removable terminal block. This protocol offers the lowest level of control.

•Profibus DP (VW3A58307U)

This card is equipped with a female 9-pin SUB-D connector for connection to cables equipped with connectors. The kit contains a set-up diskette for PLC configuration.

•CANopen (VW3A58308)

This card is equipped with a removable five-pin connector.

•Device Net (VW3A58309U)

This card is equipped with a removable five-pin connector. This option card has been tested for compliance by an ODVA test facility.

•Ethernet Modbus TCP/IP (VW3A58310U)

This card is equipped with a RJ45 connector. The cables and hubs are the same as Schneider Electric’s Transparent Factory Ethernet products. The card allows direct IP addressing through web pages embedded in the card.

•Lonworks to Modbus Gateway (VW3A58312PU)

This DIN rail mountable gateway is a Lonworks to Modbus protocol converter. The module is connected point-to-point through the supplied cable to either the ATV58 integrated keypad Modbus port or to the 9-pin connector on the Modbus option card (VW3A58303U).

•Johnson Controls METASYS N2 (VW3A58354U)

This card allows the ATV58 TRX drive controller to be integrated into an N2 network as an application-specific controller. It is equipped with a female 9-pin SUB-D connector.

•Siemens P1 Gateway

This gateway is available through third party arrangement.

32

© 2000–2003 Schneider Electric All Rights Reserved 09/2003