TROY Group MAN-EXT2000 manual Windows NT V4.xx Configuration

test). If you get the message "The arp entry addition failed: 3", try pinging a known device on the network using the command ping ipaddress, where ipaddress is the IP address of that device.

Important: You must be on the same Ethernet segment (that is, there cannot be a router between the TROY XCD print server and the Windows NT system) to use the arp -scommand. If there is a router, you may use BOOTP or other methods described in Chapter 4 to enter the IP address. Also, this method only works the first time the TROY XCD print server is configured. If the TROY XCD print server already has an IP address, you may use TELNET to access it and change the IP address using the SET IP ADDRESS command described in Appendix A.

Important: The TROY XCD print server has a default IP address of 192.0.0.192 (192.189.207.254 on older firmware versions). You must change this address to a unique value to avoid having duplicate IP addresses.

Windows NT V4.xx Configuration

Note: If you have Windows NT V3.5 or V3.51, skip to the next section.

1.Go to the Start button, choose Settings, and then select Printer. Double click on the Add Printer icon to get the Add Printer Wizard. Click. Select My Computer (Not Network Printer) and click on Next.

2.Select Add Port, select LPR Port from the list of available ports, and click on New Port.

7-4 Windows NT/LAN Server Configuration