•If you have XAdmin32, double click on the print server name and then click on the appropriate NetWare tab (NetWare P1 for the first parallel port, NetWare S1 for the first serial port, NetWare P2 for the XConnect 100 second parallel port or NetWare S2 for the XConnect 100 second serial port).
•If you are using XAdmin, one or more TROY XCD print server NetWare services will show up in the list of printers (the default service names are listed in the Default Print Server Names section at the beginning of this chapter). Double click on the one that you wish to configure and then click on the NetWare tab.
•If you are using WebXAdmin, start your web browser, enter the IP address of the print server as the destination address, and then push ENTER or RETURN. Click on Configure NetWare, and then click on the Enabled Service that you wish to configure (the default service names are listed in the Default Print Server Names section at the beginning of this chapter).
•If you are using JetAdmin, one or more TROY XCD print server NetWare services will show up in the list of printers (the default service names are listed in the Default Print Server Names section at the beginning of this chapter; note that JetAdmin supports a maximum of three ports per print server). Single click on the one you want to configure, go to the menu bar and select Device and then Modify. Then click Next and select Operating Mode.
