NOTE: If you want to enable remote printer capabilities on services other than the default NetWare services, you must define new services that are enabled for NetWare and for the desired port (only one service per port can be defined for NetWare). Refer to Appendix B in this manual for information on how to do this.
14.Select the Remote Printer as the Operating Mode, enter the name of your PSERVER NLM as the Print Server Name, and select the number of the printer from step 6 as the Printer Number (XAdmin32 and JetAdmin allow you to choose from a list of available print server NLMs rather than typing in the name).
15.If you have XAdmin 32 or XAdmin, click OK. If you have JetAdmin, click Next two times, and then click Finish. If you have WebXAdmin, click Submit.
16.Exit the configuration utility. You must now unload the PSERVER NLM from your NetWare file server console and then reload it in order for the changes to take effect.
Configuring the Print Server and Print Queue using PCONSOLE and XCONFIG (Remote Printer Mode)
To configure an TROY XCD print server for remote printer mode operation using PCONSOLE and XCONFIG, first make sure that you have V3.27 or later firmware (refer to the
1.Make sure that the PSERVER NLM (NetWare Loadable Module) is loaded on your file server.
