you are connected, enter the password (ACCESS is the default password) and select the protocol or other item that you wish to configure. You will then be connected to the appropriate web page for configuration of that item. You may use the normal browser buttons to move forward and back through the web pages.
TROY XCD Print Server Console
All TROY XCD print servers support a sophisticated command-line oriented console for configuration and management. This console contains features that are not available through XAdmin or WebXAdmin, including sophisticated diagnostic capabilities. The TROY XCD print server console can be accessed via TELNET, DEC NCP/ NCL/ccr, the print server serial port (if present), and the TROY XCD XCONFIG NetWare utility. It also available through one of the web pages using the WebXAdmin facility.
The general configuration procedure is the same regardless of which method is used.
DEC NCP, NCL, ccr. To connect to the print server console with the VMS NCP utility, use the following commands:
MCR NCP
CONNECT VIA circuit PHY ADD ethernetaddress
where circuit is the circuit-ID of the VAX or Alpha (for example, SVA-0 for most DEC workstations, MNA-0 for XMI systems, BNA-0 for BI systems, and QNA-0 for Q-BUS systems) and ethernetaddress is the hardware address of the print server (for example, 00-40-17-00-61-35).
Management Methods 3-5
