$ MCR NCP
NCP>CONNECT VIA
On ULTRIX systems, you would execute commands similar to the following example:
#addnode XCD
#ccr XCD
On a NetWare system, you would use the XCONFIG utility included with every TROY XCD print server. Simply type XCONFIG at the DOS prompt and select the desired TROY XCD print server.
b.If you are using the remote console, you will get the message Console connected (VMS) or
XCONFIG) or
Remote console reserved (ULTRIX). Press RETURN and enter the password ACCESS in response to the "#" prompt (it will not echo). Note: You will not be asked for a password if you are using the XConnect II or XConnect 100 serial port.
c.You will be prompted for a user name. Enter anything in response to this prompt (older versions do not ask for the user name).
d.You will then get the Local> prompt. Type SET
IP ADDRESS ipaddress, where ipaddress is the desired IP address you wish to assign to the TROY XCD print server (check with your network manager for the IP address to use). For example:
Local> SET IP ADDRESS 192.189.207.3
