5.You will be asked to enter a port name, which must begin with "NB" (for example NB23). Enter the desired name or accept the default NB1. Click OK.
6.Select Browse when asked for the Remote Print Server.
-Choose the desired workgroup and click Next.
-Choose the TROY XCD print server from the list of available devices. The default name of the print server is XCD_xxxxxx, where "xxxxxx" is the last six digits of the Ethernet address (for example, XCD_035893).
-Choose the desired printer (service) from the list. The default service is BINARY_P1 for the parallel port, BINARY_S1 for the serial port, BINARY_P2 for the XConnect 100 second parallel port, and BINARY_S2 for the second serial port..
-Click Finish and then OK.
7.Click Finish to restart the computer.
Note: Print servers with firmware versions 3.58 and earlier use an address of the form \\XCD_xxxxxx_pp\pp, where "xxxxxx" is the last six digits of the Ethernet address and "pp" is the port name (P1 for the parallel port, S1 for the serial pot, P2 for the second parallel port, and S2 for the second serial port).
You must then create a local (not network) printer on your system that uses this port. First go the Networks icon in the Control Panel on your workstation and make sure that you have the following enabled:
-TCP/IP or NetBEUI protocol
-Client for Microsoft Network
-Appropriate Ethernet LAN adapter card
