therefore know the name of the file server (spooler host) in addition to the above information. You will add a physical printer and a remote printer, and then assign a logical printer name to the remote printer (a unique name that does not match any other name). To print, use the lp
Earlier versions of HP/UX use similar procedures to 10.xx:
-Enter sam and select "Peripheral Devices" and then "Add Remote Printer" (not "networked printer")
-Enter the following remote printer settings (the other settings do not matter):
-Line printer name
-Remote system name (the TROY XCD print server name; must match what is in hosts file or use TROY XCD print server IP address)
-Remote printer queue (TROY XCD print server binary or text service name)
-Remote Printer is on a BSD System (Yes)
IBM RS/6000 AIX Configuration
The RS/6000 AIX operating system uses the smit program to set up the remote printer. The procedure is as follows for AIX 4.0 and later:
1.Enter SMIT and select “devices”
2.Select “Printer/Plotter”
3.Select “Print Spooling”
4.Select “Add a Print Queue”
5.Select “Remote”
6.Enter the following Remote Printer Settings:
