Appendix A

Command Summary

General Commands

Although it is not normally necessary to change the print server default parameters, you can change the configuration through any following methods:

DEC NCP or NCL Utility

TELNET

TROY XCD XCONFIG NetWare Utility

Serial Port

The general configuration procedure is the same regardless of which method is used.

Certain print server NetWare parameters (such as the NetWare service name) can also be changed by using the Hewlett-Packard JetAdmin utility or TROY XCD XAdmin utility.

DEC NCP, NCL, ccr. To connect to the print server console with the VMS NCP utility, use the following commands:

MCR NCP

CONNECT VIA circuit PHY ADD ethernetaddress

where circuit is the circuit-ID of the VAX or Alpha (for example, SVA-0 for most DEC workstations, MNA-0 for XMI systems, BNA-0 for BI systems, and QNA-0 for Q-BUS systems) and ethernetaddress is the hardware address of the

Command Summary A-1

Page 203
Image 203
TROY Group MAN-EXT2000 manual General Commands, Command Summary A-1