-Go to Print Queues, press Insert to create a new print queue, and enter the name of the print queue. If you are configuring an NDS queue, you will also need to enter a volume name (press Insert to browse for available volumes).
-Select Print Servers (NetWare 4.xx and later) or Queue Servers (NetWare 2.xx and 3.xx), press Insert and enter the name of the TROY XCD print server (the default print server names are discussed in the Default Print Server Names section at the beginning of this manual).
-Go to Print Queues, select the desired print queue, then select Print Servers and press Insert to select the name of the TROY XCD print server.
-Exit PCONSOLE.
4.Go back to XCONFIG and enter the command:
SET NETWARE RESCAN
After a few seconds, do a SHOW NETWARE command; you should see the queue you created being serviced by the file server. You are now ready to use the queue.
Configuring the Print Server and Adding the Print Queue in Remote Printer Mode
To configure a TROY XCD print server for remote printer mode, there are two basic steps required. First, you must use
