TROY Group MAN-EXT2000 manual Ultrix systems use the addnode and ccr commands as follows

Newer OpenVMS systems use NCL instead of NCP. The NCL command to connect to the print server console is:

SET HOST/MOP/CIRCUIT=circuit/ADD=ethernetaddress

ULTRIX systems use the addnode and ccr commands as follows:

addnode xciiname -ccircuit -hethernetaddress ccr xcdname

where xcdname is an arbitrary name for the print server (each print server on the network needs a unique name).

In all cases, you will get a message like Console Connected or Remote Console Reserved when you are connected. When you are connected, push RETURN or ENTER to get the "#" prompt, enter the password ACCESS (it will not print), and type anything in response to the Enter Username> prompt. When you get the Local> prompt, you are ready to enter commands.

Note: The commands available are generally a subset of the ones used on the DECserver terminal server. Note that unlike the DECserver, there is no distinction between the SET and DEFINE commands or between the CLEAR and PURGE commands. Instead, when you type CTRL-D to exit the remote console, any of these commands take effect immediately and the results are stored permanently (for example, it is not necessary to enter both a SET and a DEFINE to execute a command and save the results).

TELNET. To connect to the print server using TELNET on UNIX, Windows NT, or most other TCP/IP systems, type:

TELNET ipaddress

3-6 Management Methods