TROY Group MAN-EXT2000 manual 22 TCP/IP Network Configuration

i.Type EXIT or CTRL-D (i.e., hold down the control key and type "D") to end the remote console session.

j.With older versions of the firmware (V3.26 or earlier), you must wait about ten second and then power the printer off and then on again to make the IP address take effect (not necessary with newer versions).

6.Before attempting to print, it is very important to verify the connection between the host and the TROY XCD print server by using the UNIX ping command with the IP address of the TROY XCD print server. For example:

ping 192.189.207.3

You should get a message that the TROY XCD print server is alive. If you get an error message or no response, then there is no connection. You will not be able to print if you cannot ping the TROY XCD print server. If this is the case, verify that you have set up the host and TROY XCD print server correctly and that the physical connections (e.g., the transceivers and cabling) are good. Refer to the Troubleshooting chapter for additional information.

7.To print to the TROY XCD print server from UNIX, use the standard lpr command with the -P option to specify the queue name. For example, to print the file TEST on the queue laser1, you would type:

lpr -Plaser1 TEST

4-22 TCP/IP Network Configuration