When you type a
If the red LED does not go out after about two minutes, check to make sure that you correctly entered all parameters and that your network connections are good. Then power the print server off and then on again, enter the SET LOAD ENABLE command, and exit the remote console to retry the download.
Downloading from a Windows NT or UNIX Host Computer using Master Mode tftp
To download the print server firmware from a Windows NT or UNIX system using master mode tftp, first copy the file XJET.BIN to that host. Make sure that tftp is started by checking the appropriate files on your system (on Windows NT, TCP/IP and Simple TCP/IP Services must be enabled in the Network Control Panel); with UNIX, tftp must be enabled in your /etc/services file and possibly in another configuration file, such as /etc/inetd.conf. Refer to your system documentation or the UNIX man pages for additional information.
Important Note: Master mode tftp requires V3.46 or later firmware plus 4.6 or later boot firmware. Do a SHOW VERSION command in the print server console to verify which version you are using.
To download the firmware from Windows NT, enter the following command:
tftp - i ipaddr put file password