SET LOAD ENABLE

Power the printer off and then on again, enter the SET LOAD ENABLE command, and then type EXIT to exit the remote console and retry the download.

Downloading from a NetWare Server

To download from a NetWare server, first copy the file XJET.BIN into the \login directory on your SYS partition (SYS:\LOGIN). Using the \login directory will eliminate any potential file protection problems.

Connect to the print server remote console using XCONFIG or the serial port (refer to Appendix A if you do not know how to do this) and enter the following commands in response to Local> prompt.

SET LOAD HOST fileservername

SET LOAD SOFTWARE SYS:\LOGIN\XJET.BIN SET LOAD ENABLE

where fileservername is the name of the file server. When you type a CTRL-D to exit the remote console, the file XJET.BIN will then be loaded into the print server. The red diagnostic LED will blink during the load process and will go out when the process is complete.

If the red LED does not go out after about two minutes, check to make sure that you correctly entered all parameters and that your network connections are good. Then power the print server off and then on again, enter the

command, and exit the remote console to retry the download.

Reloading the Firmware C-7

Page 231
Image 231
TROY Group MAN-EXT2000 manual Downloading from a NetWare Server, Reloading the Firmware C-7