Configure your /etc/bootptab file to specify the Ethernet address of the print server and the name of the load file (XJET.BIN). Make sure that your file protection allows general access to the directory that contains the load file. The exact format of the file /etc/bootptab varies widely, so you will need to refer to your UNIX system documentation for details. A typical /etc/bootptab file entry might be:
xc2:ht=ethernet:ha=00401700c953:\
ip=192.189.207.3:bf=/usr/XJET.BIN:
Now log into the print server remote console using TELNET or the serial port (see Appendix A if you do not know how to do this), and execute the following commands:
SET LOAD SOFTWARE "pathname"
SET LOAD ENABLE
where
When you type a
If the red LED does not go out after about two minutes, check to make sure that you correctly entered all parameters and that your network connections are good.