position will conserve energy by drawing less power from the printer.
Note: With V3.22 or earlier firmware (included with XConnect II and XConnect II Lite print servers shipped from TROY XCD prior to September, 1995), switches 2 and 3 must both be in the OFF position for 10baseT operation or in the ON position for 10base2 operation.
Switch 4 (Console/Serial Printer)
This switch defines whether the serial port will be used for a console terminal or a serial printer. Leave switch 4 in the default OFF position if you want to use the serial port for a console terminal.
XConnect 100 Front View
Test LED | Link OK LED |
100baseTX LED
XConnect 100 Rear View
Test Switch |
|
| Console/ | Parallel Port 2 | |||
|
| Serial Port 2 | |||||
|
|
|
|
|
| ||
100baseTX/ |
| Serial Port 1 | Parallel Port 1 | Power Connector | |||
10baseT | Serial ports are |
| |||||
Connector |
|
Figure
XConnect 100 Switch and LEDs