Polycom 2000/4000 B-9, , ,

Polycom RMX 2000/4000 Administrator’s Guide
B-9
Internal MCU reset Possible explanations:
•McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name].
•McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name]; Cannot reset while system is in DEBUG
mode.
•Power down signal was detected.
•[CS Component Failure; unit type:
[NonComponent\CSMngnt\CSH323\CSSIP]\CS
Component Failure; unit type: (invalid: [unit type])\No
connection with CS]; Cannot reset while system is in
DEBUG mode.
•Reset cause unknown: [reset source]\Restore
Factory Defaults - [mcu restore name]\CM_Loaded
indication repeate d; boardId: [boardId]\reset from
Cards process - simulation\No connection with MPM;
board Id:[boardId]\SmMfaFailure - boardId: [boardId].
Status: [status], problem bitmask:
[problemBitMask]\MPM failure, boardId:
[slotId]\Switch failure\No connection with Switch.
Internal System configuration during
startup System configuration during startup.
Invalid date and time Invalid date and time:
MCU year ([year]) must be 2000 or later.
Invalid MCU Version MCU Version: [Major.Minor.release.internal].
Invalid System Configuration
IP addresses of Signaling Host and
Control U nit are the same
IP Network Service configuration modified IP Network Service was modified.
Reset the MCU.
IP Network Service deleted IP Network Service was deleted.
Reset the MCU.
Table B-1 Alarms (Continued)
Alarm Code Alarm Description