Force10 Networks S2410s manual Snmptrap ipaddr, Snmptrap mode

snmptrap

Command
	Version 2.3	Corrected from snmp-server enable traps
History

snmptrap

	This command adds an SNMP trap receiver name and trap receiver IP address. The maximum
	name length is 16 case-sensitive alphanumeric characters.
Syntax	[no] snmptrap name ipaddr
	The no version of this command deletes the specified trap receiver from the community.
Mode	Global Config

snmptrap ipaddr

	This command assigns an IP address to a specified community name. The maximum name
	length is 16 case-sensitive alphanumeric characters.
		Note: IP addresses in the SNMP trap receiver table must be unique. If you make
		multiple entries using the same IP address, the first entry is retained and processed.
		All duplicate entries are ignored.
Syntax	snmptrap ipaddr name ipaddrold ipaddrnew
Mode	Global Config

snmptrap mode

	This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able
	to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Syntax	[no] snmptrap mode name ipaddr
	The no version of this command deactivates an SNMP trap. Disabled trap receivers are
	inactive (not able to receive traps).
Mode	Global Config

102 System Management Commands