Force10 Networks S2410s manual Vlan participation management, Telnet Commands

		vlan participation (management)
Related
	show hardware	Inventory information for the switch
Commands
	show logging	Trap log maintained by the switch, and event log, containing error
		messages from the system
	show port	Port information
	show running-config	Updated configuration maintained by the switch.
	show version	Details of the software/hardware present on the system

vlan participation (management)

Syntax

Mode

Default

Command History

Related Commands

This command assigns the management VLAN of the switch.

[no] vlan participation vlan_id

The value for vlan_id is the VLAN that you want to use for the management interface (By default, VLAN 1 is used.)

Interface ManagementEthernet. Uses the (Config-if-ma)# prompt, accessed by interface

managementethernet.

VLAN 1 (default management VLAN; all enabled ports are on VLAN 1 by default, so all ports are capable, by default, of being management ports.)

Version 2.3	Introduced: Replaces the network mgmt_vlan command.
management route default		Sets the IP gateway of the switch.
interface managementethernet		Invokes the Interface ManagementEthernet mode, the
		(Config-if-ma)# prompt.
show interface		Displays a summary of statistics for a specific port,
		including the management port, or a count of all CPU
		traffic based upon the argument.

Telnet Commands

This section describes the following SFTOS Telnet commands:

•ip telnet maxsessions on page 88

•ip telnet timeout on page 88

•session-limit on page 89

•session-timeout on page 89

•show telnet on page 90

•telnet on page 90

SFTOS Command Reference for the S2410, Version 2.4.1.0 87