Force10 Networks S2410s manual Deleteport interface config, Addport unit/slot/port

deleteport (interface config)

Syntax

Mode

Command History

Related Commands

In Ethernet Range mode (Interface Range mode for the selected range of physical ports), this command adds the selected ports to the designated LAG.

addport unit/slot/port

Specify the LAG ID in its logical slot/port format (e.g., 1/4).

Interface Config; Interface Range (specifically Ethernet Range, which is indicated by the (conf-if-range-et-[interfaces])# prompt, such as (conf-if-range-et-1/0/10-1/0/11)#).

Version 2.3	Added Interface Range mode
interface range	Defines an interface range and accesses the Interface Range mode
deleteport (interface config)	Deletes the selected port from the designated LAG or, in Interface
	Range mode, the selected range of ports.
show port-channel	Display the configured LAG names and their IDs. The interface
	number is specified in logical slot/port format, which displays one (1)
	as the slot number; the port number is a sequential integer, based on
	existing LAG numbers when the new LAG is created.
	Before adding ports to the newly defined LAG, use this command to
	determine the logical ID that identifies the LAG to use when
	associating a port with it.

deleteport (interface config)

Syntax

Mode

Command History

Related Commands

This command deletes the selected port from the LAG (port channel) or, in Interface Range mode, the selected range of ports.

deleteport unit/slot/port

Interface Config; Interface Range (specifically Ethernet Range, which is indicated by the (conf-if-range-et-[interfaces])# prompt, such as (conf-if-range-et-1/0/10-1/0/11)#).

Version 2.3	Interface Range mode added
show port-channel	Display the configured LAG names and their IDs. The interface
	number is specified in logical slot/port format, which displays one (1)
	as the slot number; the port number is a sequential integer, based on
	existing LAG numbers when the new LAG is created.
	Before adding ports to the newly defined LAG, use this command to
	determine the logical ID that identifies the LAG to use when
	associating a port with it.

250 LAG/Port Channel Commands