Force10 Networks S2410s manual Management IP Address, Ssh

Note: Keywords and parameters that are shown within braces in syntax statements must be entered in the CLI. Keywords and parameters that are shown separated by a bar in syntax statements require you to choose one. Parameters in italics are variables for which you substitute a value. see Command Syntax Conventions on page 39.

Management IP Address

In addition to logging into the CLI to view and manage network parameters, you can use the following methods:

•Simple Network Management Protocol (SNMP)

•SSH

•Telnet

•SFTOS Web User Interface (Web UI) through a Web browser (See Using the Web User Interface on page 51.)

Each of these methods require that you first use the CLI through the console port to configure a management IP address, subnet mask, and default gateway. The S2410 actually provides the ability to configure two management IP addresses:

•An IP address that accesses the Ethernet Management port, an RJ-45/Ethernet port dedicated to managing the switch: See Configuring the Ethernet Management Port on page 36).

•An IP address that accesses the management VLAN running on a configurable set of the other physical ports. See the following procedure.

Helpful Hint: After configuring the network parameters, execute write memory so that the configuration changes are not lost.

Alternatively, you can execute copy system:running-config nvram:startup-config (if you love to type).

SFTOS Command Reference for the S2410, Version 2.4.1.0 35