Force10 Networks S2410s manual Show interface managementethernet

show interface managementethernet

show interface managementethernet

Syntax

Mode

Command History

Usage Information

This command displays information about the management address of the switch.

show interface managementethernet

Privileged Exec

Version 2.3 Modified: Added the keyword managementethernet to show interface to provide the information that had been available through the show network command.

The display parameters of the show interface command, when the keyword is managementethernet, are as follows:

Table 9 Fields in Output of show interface managementethernet command

Field	Description
IP Address	The IP address of the interface. The factory default value is
	0.0.0.0
Subnet Mask	The IP subnet mask for this interface. The factory default value
	is 0.0.0.0
Default Gateway	The default gateway for this IP interface. The factory default
	value is 0.0.0.0
Burned In MAC Address	The burned in MAC address used for in-band connectivity
Java Mode	Enable or Disable. Specifies if the switch should allow access to
	the Java applet in the header frame. Enabled means the applet
	can be viewed. The factory default is disabled.
Locally Administered MAC Address	If desired, a locally administered MAC address can be
	configured for in-band connectivity. To take effect, 'MAC Address
	Type' must be set to 'Locally Administered'. Enter the address as
	twelve hexadecimal digits (6 bytes) with a colon between each
	byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, i.e. byte 0
	should have the following mask 'xxxx xx10'. The MAC address
	used by this bridge when it must be referred to in a unique
	fashion. It is recommended that this be the numerically smallest
	MAC address of all ports that belong to this bridge. However it is
	only required to be unique. When concatenated with
	dot1dStpPriority a unique BridgeIdentifier is formed which is
	used in the Spanning Tree Protocol.
MAC Address Type	Specifies which MAC address should be used for in-band
	connectivity. The choices are the burned in or the Locally
	Administered address. The factory default is to use the burned
	in MAC address.
Management VLAN ID	Specifies the management VLAN ID.
Network Configuration Protocol	Indicates which network protocol is being used. The options are
Current	bootp dhcp none.
Web Mode	Enable or Disable

SFTOS Command Reference for the S2410, Version 2.4.1.0 75