Force10 Networks S2410s manual Spanning-tree edgeport, Spanning-tree forceversion, Words

spanning-tree edgeport

	The no version of this command sets the Configuration Identifier Revision Level for use in
	identifying the configuration that this switch is currently using to the default value, in other
	words, 0.
Syntax	spanning-tree configuration revision 0-65535
Default	0
Mode	Global Config

spanning-tree edgeport

Syntax

Mode

Command

History

Related

Commands

This command specifies that this port is an edge port (portfast) within the common and internal spanning tree. This will allow this port to transition to forwarding state without delay.

The no version of this command specifies that this port is not an Edge Port within the common and internal spanning tree.

[no] spanning-tree edgeport

Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Version 2.3	Added Interface Range mode.
interface	Identifies an interface and enters the Interface Config mode.
interface range	Defines an interface range and accesses the Interface Range mode

spanning-tree forceversion

This command sets the Force Protocol Version parameter to a new value. The Force Protocol Version can be one of the following:

•802.1d - STP BPDUs are transmitted rather than MST BPDUs (IEEE 802.1D functionality supported)

•802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality supported)

•802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)

The no version of this command sets the Force Protocol Version parameter to the default value, in other words, 802.1s.

SFTOS Command Reference for the S2410, Version 2.4.1.0 267