Force10 Networks S2410s manual Show interface, Managementethernet, Interface, Management route

Configuring the Management VLAN IP Address

To configure the management VLAN IP address, use the following commands:

Command Syntax	Command Mode	Purpose
show interface	Privileged Exec	Displays the Network Configurations
managementethernet		IP Address: IP Address of the interface. Default IP is 0.0.0.0
		Subnet Mask: IP Subnet Mask for the interface. Default is 0.0.0.0
		Default Gateway: The default Gateway for this interface. Default
		value is 0.0.0.0
		Burned in MAC Address: The Burned in MAC Address used for
		in-band connectivity
		Locally Administered MAC Address: Can be configured to allow a
		locally administered MAC address
		MAC Address Type: Specifies which MAC address should be used
		for in-band connectivity
		Network Configurations Protocol Current: Indicates which network
		protocol is being used. Default is none.
		Management VLAN Id - Specifies VLAN id
		Web Mode: Indicates whether HTTP/Web is enabled.
		Java Mode: Indicates whether java mode is enabled.
interface	Global Config	Invokes the (Config-if-ma)# prompt, at which you can execute the ip
managementethernet		address command.
ip address ipaddr	Interface Config	Configure the management IP address and subnet mask:
netmask		IP Address range from 0.0.0.0 to 255.255.255.255
		Subnet Mask range from 0.0.0.0 to 255.255.255.255
management route	Global Config	Set the default gateway.
default gateway		Gateway Address range from 0.0.0.0 to 255.255.255.255

For details on command syntax for the commands listed above, see General System

Management and Information Commands on page 55.

Configuring the Ethernet Management Port

To configure the IP address of the Ethernet Management port, use the following commands:

Command Syntax	Command Mode	Purpose
serviceport protocol	Global Config	Specify the network configuration protocol to be used (Bootp or
{none bootp dhcp}		DHCP) for configuring access to the Ethernet Management port.
		Alternatively, leave the default at none and then manually configure
		the IP information.
serviceport ip ipaddr	Global Config	Manually configure the IP address, IP subnet mask, and default IP
netmask [gateway]		gateway of the Ethernet Management port (service port).
show serviceport	Privileged Exec	Verify the Ethernet Management port configuration.

36 Quick Start