Force10 Networks S2410s manual Enable, User Exec, Password for the command

enable

Syntax

Command Modes

Usage

Information

configure

Privileged Exec

Users executing this command enter the Global Config mode, which provides access to many commands within that mode. Also, this mode is a gateway to all other more protocol-specific modes except the VLAN mode.

For details on modes, see Chapter 3, Using the Command Line Interface, on page 39.

Example

(S50) #configure

(S50) (Config)#

Figure 19 configure Command Example

Related	enable	The enable command accesses the Privileged Exec mode.
Commands

enable

	This command accesses the Privileged Exec mode from the User Exec mode. If the enable
	password is set, you must enter the password to gain access to the Privileged Exec mode.
		Note: In a stack, only the management unit (stack manager) provides access to CLI
		commands. Other member units display the prompt “(Unit [unit number])”.
Syntax	enable
Defaults	none
Mode	User Exec
Usage	Users who execute this command enter the Privileged Exec mode, gaining access to the
Information	commands available in this mode, as well as being able to directly access the Global Config
	mode and the VLAN mode. After accessing the Global Config mode, users can access all
	modes to which the Global Config mode provides a gateway.
	To protect against unauthorized access, use the command enable passwd to configure a
	password for the command.
Example	(S50)>enable
	Password:
	(S50)#
	Figure 20 enable Command Example

SFTOS Command Reference for the S2410, Version 2.4.1.0 107