Force10 Networks S2410s manual Set garp timer leave, Set garp timer join No set garp timer join

set garp timer leave

Syntax

Default

Mode

Command

History

Related

Commands

This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds). the value 20 centiseconds is 0.2 seconds.

set garp timer join 10-100

no set garp timer join

The no version of this command sets the GVRP join time per port and per GARP to 20 centiseconds (0.2 seconds). This command has an effect only when GVRP is enabled.

20 centiseconds

Interface Config, Global Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Version 2.3	Interface Range mode added
interface range	Defines an interface range and accesses the Interface Range mode

set garp timer leave

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60 centiseconds is 0.6 seconds.

Syntax set garp timer leave 20-600

Use no set garp timer leave to set the GVRP leave time per port to 60 centiseconds (0.6 seconds).

Default 60

Note: This command has an effect only when GVRP is enabled.

Mode

Command

History

Related

Commands

Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Version 2.3	Interface Range mode added
interface range	Defines an interface range and accesses the Interface Range mode

226 GARP, GVRP, and GMRP Commands