Force10 Networks S2410s manual System Info and System Setup, Boot Menu Options, Show hardware

2.At the [Boot Menu] prompt, press the number and Enter of the option that you want. The options are:

Table 1 Boot Menu Options

Boot Menu Options		Details
1	- Start operational code	Start SFTOS (the same option as presented in the
		two-option startup menu).
2	- Change baud rate	Invoke a menu that offers console speed settings
		from 9600 to 115kb.
3	- Retrieve event log using XMODEM (64KB).	Upload a text file of the event log to an external folder
		through Xmodem running on the console. After
		selecting this option, you are given the chance to
		cancel the transfer by typing Ctrl-xseveral times.
4 - Load new operational code using XMODEM		Download a new version of SFTOS from an external
		folder through Xmodem running on the console.
5	- Display operational code vital product data	Lists SFTOS version and installed modules.
6	- Update Boot Code	[not active]
7	- Delete operational code	Remove the installed version of SFTOS. You might
		do this if you need to remove a corrupted image or if
		the NVRAM is too full to download a new version of
		SFTOS.
8	- Reset the system	This is the same as power cycling.
9	- Restore Configuration to factory defaults	Replace the startup-config with the default config.
(delete config files)

For details on other Xmodem options, see Uploading from the Switch through XMODEM on page 37 and Downloading to the Switch through XMODEM on page 37. In general, for more information on options related to the Boot menu options, see the section “Managing Configuration and Software Files” in the SFTOS Configuration Guide.

System Info and System Setup

To get information on the software version, use the show hardware command:

Command Syntax	Command Mode	Purpose
show hardware	Privileged Exec	Displays the serial number, software version the device contains,
		burned-in MAC address, and other device information.

SFTOS Command Reference for the S2410, Version 2.4.1.0 33