Force10 Networks S2410s Monitor session, Be only one destination port, Destination interface

monitor session

monitor session

This command adds a mirrored port (source port) or probe port (destination port) to a session identified with the session ID of 1. In all released versions of SFTOS, the session is always 1.

Syntax	[no] monitor session 1 {destination interface unit/slot/port source interface
	unit/slot/port mode}
Parameters	destination interface	Specify the probe port (target port). The probe port can be a VLAN
	unit/slot/port	member only if you first add the port to a VLAN and then configure it
		as a probe port.
	source interface unit/ Specify the source interface (mirrored port). The port can be a part of
	slot/port	any VLAN.
	mode	Enable/disable the port mirroring session. See monitor session 1
		mode on page 113.
	To remove the destination port, use no monitor session 1 destination interface.
	To remove a source port, use no monitor session 1 source interface unit/slot/port.
	In other words, removing the source interface requires specifying the port to be removed, but
	removing the destination port does not require specifying the destination port, since there can
	be only one destination port.
Default	None
Mode	Global Config
Usage	Note the restrictions described above on using mirrored and probe ports in VLANs.
Information	Furthermore, if either port is in a VLAN, then the other port must also be in the same VLAN.
	Remove an existing source or destination port before replacing it with another. For more on
	configuring port monitoring (port mirroring), see the Port Mirroring chapter of the SFTOS
	Configuration Guide.
Related
	monitor session 1 mode	Sets the monitor session (port monitoring) mode to enabled.
Commands
	no monitor	Removes the destination port and all source ports from the mirroring
		configuration.
	show monitor session	Shows the mirroring configuration.

112 System Configuration Commands