Force10 Networks S2410s manual Telnetcon maxsessions, Serial baudrate, Serial Commands

telnetcon maxsessions

telnetcon maxsessions

Command
	Version 2.3 Modified: Changed to ip telnet maxsessions
History

Serial Commands

	This section describes the following SFTOS system management commands pertaining to
	console port connections (serial connections, EIA-232):
	• lineconfig on page 91
	• serial baudrate on page 91
	• serial timeout on page 92
	• show serial on page 92
lineconfig
	This command accesses the Line Config mode from the Global Config mode.
Syntax	lineconfig
Mode	Global Config
Usage	Users executing this command enter the Line Config mode.
Information
	For details on modes, see Chapter 3, Using the Command Line Interface, on page 39.
Example	(S50) #configure
	(S50) (Config)#lineconfig
	(S50) (Line)#

Figure 18 lineconfig Command Example

Related
	configure	Accesses the Global Config mode, which is the mode in which you can
Commands
		execute this lineconfig command.

serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.

Syntax serial baudrate {1200 2400 4800 9600 19200 38400 57600 115200}

SFTOS Command Reference for the S2410, Version 2.4.1.0 91