Force10 Networks S2410s manual Show trapflags Fields of show snmptrap Command Report

show trapflags

Table 16 Fields of show snmptrap Command Report

Field	Description
SNMP Trap Name	The community string of the SNMP trap packet sent to the trap manager. This
	may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address	The IP address to receive SNMP traps from this device. Enter four numbers
	between 0 and 255 separated by periods.
Status	Indicates the receiver's status (enabled or disabled)

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to implement the changes. Cold start traps are always generated and cannot be disabled.

Note: The DVMRP, OSPF, and PIM traps are not supported in the Layer 2 image.

Syntax	show trapflags
Mode	Privileged Exec
	Table 17 Fields of show trapflags Command Report
	Field	Description
	Authentication Flag	May be enabled or disabled. The factory default is enabled. Indicates whether
		authentication failure traps will be sent.
	Link Up/Down Flag	May be enabled or disabled. The factory default is enabled. Indicates whether
		link status traps will be sent.
	Multiple Users Flag	May be enabled or disabled. The factory default is enabled. Indicates whether a
		trap will be sent when the same user ID is logged into the switch more than once
		at the same time (either via telnet or serial port).
	Spanning Tree Flag	May be enabled or disabled. The factory default is enabled. Indicates whether
		spanning tree traps will be sent.
	DVMRP Traps	May be enabled or disabled. The factory default is disabled. Indicates whether
		DVMRP traps will be sent.
	OSPF Traps	May be enabled or disabled. The factory default is disabled. Indicates whether
		OSPF traps will be sent.
	PIM Traps	May be enabled or disabled. The factory default is disabled. Indicates whether
		PIM traps will be sent.

96 System Management Commands