Force10 Networks S2410s manual Terminal length, Traceroute, Lines Use Exec or Privileged Exec

terminal length

terminal length

Syntax

Parameters

Defaults

Mode

Command History

Usage Information

Configure the number of lines to be displayed on the terminal screen in one page of output of “show” commands.

terminal length number-of-lines

number-of-linesEnter the number of lines that you want the output to display before pausing. Entering zero (0) will cause the terminal to display without pausing.

Range: 05 to 512. (1-4 cannot be set.)

Default: 24 lines.

24 lines

Use Exec or Privileged Exec

Version 2.3 Introduced

This is a session-based command. The CLI presents 24 lines per page of “show” command output, as a default, unless the user uses this command to change the number of lines. At the end of each page, the user can press q for quit—to stop the output and return to the command line—or any other key to see the next page of the display.

Related	show terminal length	Displays the number of lines set by terminal length.
Commands
	show tech-support	Use show tech-supportnon-pagedfor uninterrupted output.

traceroute

	This command is used to discover the routes that packets actually take when traveling to their
	destination through the network on a hop-by-hop basis.
Syntax	traceroute ipaddr [port]
	ipaddr should be a valid IP address.
	The optional port parameter is the UDP port used as the destination of packets sent as part of
	the traceroute. This port should be an unused port on the destination system. It should be a
	valid decimal integer in the range of 0 (zero) to 65535. The default value is 33434.
Mode	Privileged Exec

SFTOS Command Reference for the S2410, Version 2.4.1.0 145