Force10 Networks S2410s manual Dvlan-tunnel ethertype 802.1Q vman custom, Vman

Chapter 12 VLAN-Stack Commands

VLAN-Stack commands, also called Double VLAN tagging, QinQ, and VLAN tunneling. With this feature, you can “stack” VLANs into one tunnel and switch them through the network. The commands in this chapter, in order, are:

•dvlan-tunnel ethertype on page 221

•mode dot1q-tunnel on page 222

•mode dvlan-tunnel on page 222

•show dot1q-tunnel on page 223

•show dvlan-tunnel on page 224

dvlan-tunnel ethertype

Syntax

Default

Mode

Command History

Web User Interface

Related Commands

This command configures the etherType for all VLAN-Stack interfaces on the system.

dvlan-tunnel ethertype {802.1Q vman custom 0-65535}

The etherType may have the values of 802.1Q, vman, or custom. For custom, the value of the etherType must be set to a number from 0 to 65535.

The no version of this command sets the etherType for the specified interface to the default.

vman

Global Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.

Version 2.3 Interface Range mode added

Double VLAN Tunneling (The Double VLAN Tunneling panel is the SFTOS Web Interface panel with similar functionality. Access it in the node tree through System >> Port >> Double VLAN Tunneling.)

interface range	Defines an interface range and accesses the Interface Range mode
show dot1q-tunnel	Displays the configured etherType and other information about Double
	VLAN Tunneling for a specified interface or for all interfaces.
show dvlan-tunnel	same as above

SFTOS Command Reference for the S2410, Version 2.4.1.0 221