Force10 Networks S2410s manual Bulk Configuration Warning Message, Single Range Bulk Configuration

interface range

Example

Force10(config)#interface range vlan 10 - 20

%Warning: Non-existing ports (not configured) are ignored by interface-range

(conf-if-range-vlan 10-20)#

Figure 22 Bulk Configuration Warning Message

Figure 23 is an example of a correctly formatted single range bulk configuration.

Example

Force10(config)#interface range ethernet 5/0/1-5/0/23

Force10(config-if-range)#no shutdown

Force10(config-if-range)#

Figure 23 Single Range Bulk Configuration

Figure 24 shows how to use commas to add different interface types to the range enabling all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both 10-Gigabit Ethernet interfaces 1/ 0/49 and 1/0/50.

Example

Force10(config)#interface range ethernet 5/0/1-23,1/0/49,1/0/50

Force10(config-if-range)#no shutdown

Force10(config-if-range)#

Related Commands

Figure 24 Multiple Range Bulk Configuration for Gigabit Ethernet

Use the show running-configcommand to view the VLAN and port channel interfaces. VLAN or port channel interfaces that are not displayed in the show running-configcommand cannot be used with the bulk configuration feature of the interface range command. Note that you can only modify, not create, virtual interfaces (ethernet, port channel, VLAN) using the interface range command.

Note: If a range has VLAN, physical, and port channel interfaces, only commands related to physical interfaces can be bulk-configured. To configure commands specific to VLAN or port channel, only those respective interfaces should be configured in a particular range.

interface	Accesses the Interface Config mode for a designated logical or physical interface.
interface vlan	Creates a new VLAN and accesses the Interface VLAN mode for it, or selects an
	existing VLAN and accesses the Interface VLAN mode for it.
port-channel

SFTOS Command Reference for the S2410, Version 2.4.1.0 111