Force10 Networks S2410s manual Show storm-control unit/slot/port all

show storm-control

Broadcast Storm Control Commands

This section contains the following commands:

•show storm-control

•storm-control broadcast on page 200

•storm-control flowcontrol on page 200

Note: This feature works on the 10G ports of the S2410, but because of S2410 hardware limitations, broadcast storm recovery counters are not incremented.

show storm-control

	This command displays switch configuration information.
Syntax	show storm-control [unit/slot/port all]
Mode	Privileged Exec
	Broadcast Storm Recovery Mode—May be enabled or disabled. The factory default is disabled.
	802.3x Flow Control Mode—May be enabled or disabled. The factory default is disabled.
Example	Force10-S50 #show storm-control
	802.3x Flow Control Mode						Disable
	Force10-S50 #show storm-control 1/0/1
	Intf	Bcast	Bcast	Mcast	Mcast	Ucast	Ucast
		Mode	Level	Mode	Level	Mode	Level
	------ ------- -------			------- -------		------- -------
	1/0/1	Disable	5	Disable	5	Disable	5

Force10-S50 #show storm-control all ?

<cr>			Press	enter to execute		the command.
Force10-S50 #show storm-control all
Intf	Bcast	Bcast	Mcast	Mcast	Ucast	Ucast
	Mode	Level	Mode	Level	Mode	Level
------ ------- -------			-------	-------	------- -------
1/0/1	Disable	5	Disable	5	Disable	5
1/0/2	Disable	5	Disable	5	Disable	5
1/0/3	Disable	5	Disable	5	Disable	5
1/0/4	Disable	5	Disable	5	Disable	5
1/0/5	Disable	5	Disable	5	Disable	5
1/0/6	Disable	5	Disable	5	Disable	5
1/0/7	Disable	5	Disable	5	Disable	5
1/0/8	Disable	5	Disable	5	Disable	5
1/0/9	Disable	5	Disable	5	Disable	5
!-----------	output truncated---------------				!

Figure 46 Command Example: show storm-control

SFTOS Command Reference for the S2410, Version 2.4.1.0 199