Force10 Networks S2410s manual Show telnet, Telnetcon timeout

show telnet

	The no version of this command sets the outbound Telnet session timeout value to the
	default.
Default	1 (minute)
Mode	Line Config

show telnet

	This command displays the current outbound telnet settings.
Syntax	show telnet
Modes	Privileged Exec and User Exec
	Outbound Telnet Login Timeout (in minutes)—Indicates the number of minutes an outbound telnet
	session is allowed to remain inactive before being logged off. A value of 0, which is the default, results in
	no timeout.
	Maximum Number of Outbound Telnet Sessions—Indicates the number of simultaneous outbound
	telnet connections allowed.
	Allow New Outbound Telnet Sessions—Indicates whether outbound telnet sessions will be allowed.

telnet

This command establishes a new outbound Telnet connection to a remote host. The host value must be a valid IP address. Valid values for port should be a valid decimal integer in the range of 0 to 65535, where the default value is 23. If [debug] is used, the current telnet options enabled is displayed. The optional line parameter sets the outbound telnet operational mode as ‘linemode’, where by default, the operational mode is ‘character mode’. The noecho option disables local echo.

Syntax telnet host [port] [debug] [line] [noecho]

Modes Privileged Exec and User Exec

telnetcon timeout

Command
	Version 2.3	Modified: Changed to ip telnet timeout.
History

90 System Management Commands