Force10 Networks S2410s manual Snmp Management Commands, Show serial, Global Config mode

show serial

SNMP Management Commands

This section describes the SNMP system management commands supported by SFTOS:

•show snmpcommunity on page 95

•show snmptrap on page 95

•show trapflags on page 96

•snmp-server on page 97

•snmp-server community on page 97

•no snmp-server community on page 97

•snmp-server community ipaddr on page 98

•snmp-server community ipmask on page 98

•snmp-server community mode on page 98

•snmp-server community ro on page 99

•snmp-server community rw on page 99

•snmp-server enable traps bcaststorm on page 99

•snmp-server enable traps linkmode on page 100

•snmp-server enable traps multiusers on page 100

•snmp-server enable traps stpmode on page 101

•snmp-server enable trap violation on page 101

•snmp-server traps enable on page 101

•snmptrap on page 102

•snmptrap ipaddr on page 102

•snmptrap mode on page 102

•snmp trap link-status on page 103

•snmp trap link-status all on page 103

•snmptrap snmpversion on page 103

Note: The Layer 3 Routing Package of SFTOS also contains these SNMP traps:

In Global Config mode:

•[no] ip dvmrp trapflags: Sets the DVMRP (Distance Vector Multicast Routing Protocol) traps flag (disabled by default). See the Multicast chapter.

•[no] ip pim-trapflags: Sets the PIM traps flag (disabled by default). See the PIM chapter.

In Router OSPF Config mode:

•[no] trapflags: Sets the OSPF traps flag. See the OSPF chapter (enabled by default).

For information on configuring SNMP, see the Management chapter in the SFTOS

Configuration Guide.

94 System Management Commands