If you install a voice messaging system, assign the system extensions associated with the voice messaging system hardware to Hunt Group 7. Then, use this procedure to assign outside lines to Hunt Group 7 for Automated Attendant Service. Callers hear a greeting and are prompted to enter digits to transfer to a specific extension or group without the assistance of the receptionist.

Valid Entries

1=

2=

3=

Assigned (for hunting to groups 1–6, or to group 7 for the voice messaging system’s Automated Attendant Service)

Not Assigned

VMS Line Cover (available only for Hunt Group 7)

Programming

1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 2 ] [ 0 ] [ 6 ].

2.At the Group: prompt, enter a group number (1–6; 7 for the voice messaging

system). For example, to select group 1, press [ 1 ].

3.At the Line: prompt, enter the desired line number. For example, to select line 1, press [ 0 ] [ 1 ].

4.To assign or remove a line for groups 1–6, or to assign or remove a line or use VMS Line Cover for group 7, press [ Next Data ] until the appropriate value displays.

5.At this point:

To program another line, press [ Next Item ] or [ Prev Item ] until the line number shows on the display. Then repeat Step 4.

To program another group, press [ Next Procedure ] [ Prev Procedure ], enter a new group number, and repeat Steps 3 and 4.

6.Select another procedure or exit programming mode.

Group Call Distribution (#206) 5-95

Page 192
Image 192
Lucent Technologies 4.1 manual Valid Entries