NEC 2000 IPS manual Wireless Feature Descriptions

Chapter 9 Descriptions

Wireless Feature Descriptions

Analog PBX Interface

This feature allows the WCS to be integrated with many types of PBXs and to activate various PBX services by sending hook flash signal and DTMF tone.

Announcement - PS No Answer /

Announcement - PS Out of Zone

This feature allows calls to a Dterm PS III which cannot be paged in a predetermined period of time to be routed to the announcement notifying the calling party that the Dterm PS III cannot answer. Announcements can be divided between Announcement-PS No Answer and Announcement-PS Out of Zone depending on the Dterm PS III condition.

Automatic Release - Out of Zone Calls

When a Dterm PS III user engaged in a call moves out of the service area or enters a radio zone where all the channels are busy and the communication becomes unavailable, the call will be disconnected automatically, and the other party receives reorder tone.

Call Forwarding-Not Available

When a Dterm PS III is powered off or out of zone, a call directed to the Dterm PS III is forwarded to a VMS, and a voice mail message can be recorded to the VMS and checked from the Dterm PS III. Also the VMS can page the Dterm PS III automatically after the voice mail message is recorded.

Call Forwarding - PS Out of Zone

This feature allows calls directed to a Dterm PS III, which is power off or out of zone to be routed to an another station, an Attendant, an outside number or voice mail equipment. The call forwarding destination can be set/ cancelled from the Dterm PS III station or MAT/CAT.

CCIS Interface

This feature allows the WCS to be integrated with NEC PBXs with CCIS interface.

Calling Name Display - PS

Without answering incoming calls or hold calls terminates to the Dterm PS III, the calling party’s name can be confirmed by the indications on the LCD.

Calling Number Display - PS

This feature provides a display on the LCD of a Dterm PS III receiving a call, indicating the station number.

DTMF Signal Sender

This feature allows a Dterm PS III user to send the DTMF signal (tone) to the called party (terminal, voice mail system, etc.) while engaged in communication.

Group Call-Automatic Conference (6/10-Party)

This feature permits a Dterm PS III user, Multiline Terminal user or Single Line Telephone user within the system to establish a conference among as many as six or ten parties. From a Dterm PS II/D term /Single Line Telephone, a maximum of 9 PSs can be paged simultaneously except the conference leader. The PSs are assigned to the simultaneous paging groups as participants by the system data beforehand.

UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide	Page 9- 47
Issue 6