Chapter 1 Introduction
Page 1-16 UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
Issue 6
Advantages of Remote PIM The system regards the terminals accommodated in both Main Site and Remote Site as the
extensions in the same office. Therefore, the service transparency is superior to CCIS.
Remote PIM over IP has no limitation of distance between Main and Remote.
Remote Site has a switching function at local. This provides the effective configuration of C.O.
line. In addition, the Remote Site can accommodate AP cards. This is an advantage to
accommodate ISDN lines especially.
The Remote Site survives by itself even if the link between Main and Remote is disconnected.
Therefore, the impact to users at the Remote Site will be smaller if the link between Main and
Remote is disconnected.
This feature can reduce the bandwidth used on the WAN that is connected to CO lines at
Remote Site, rather than DtermIP at remote location or the Media Converter (MC)
accommodation.
Characteristics of the UNIVERGE NEAX IPS DM/IPS DML/IPS DMR Compact and Small Size MODULAR CHASSIS
One MODULAR CHASSIS provides 8 card slots /56LT ports (8 virtual LT ports are available per
MODULAR CHASSIS in addition to 56LT ports).
2 MODULAR CHASSIS can be used per system for IPS DM/DML/IPS DMR
MP (Main Processor)
PN-CP24A/B/C for IPS DM, the same MP as the UNIVERGE NEAX2000 IPS.
PN-CP31C for IPS DML and PN-CP31A/C for IPS DMR
Power Failure Transfer (PFT)
Power Failure Transfer (PFT) for the IPS DM is provided with PZ-4PFTA card. The PZ-8PFTB is not
available for the IPS DM.
Installation Methods
The UNIVERGE NEAX IPS DM/IPS DML/IPS DMR can be installed on a desktop or into the 19-inch
rack. Wall Mount Installation is not available.
Remote PIM over IP with Survivability
The UNIVERGE NEAX 2000 IPS can have a PIM installed at a remote site through an IP network. At
the main site, the UNIVERGE NEAX IPS/IPS DM is installed and UNIVERGE NEAX 2000 IPS/IPS
DM/IPS DMR or IPS Retro is installed at the remote site. The main site controls call processing and
service feature access for station users located at both the main and remote sites. When the Remote
PIM cannot be connected with main site due to the IP network and/or main PBX failure, the Remote
PIM initializes the system and re-starts operation by its own Main Processor (survival mode). In the
survival mode, almost all service features are provided to the station users accommodated in Remote
PIM. When the IP network/main PBX recovers, the Remote PIM can be restored to normal mode with
a system initialization by manual operation or automatically (Selectable by system data setting).
IPS DMR with CP31A/C MP
IPS PIM with CP24A/B/C or CP27A MP
IPS Retro with CP26 or CP28 MP